Find intersections - to reference lines

jsc · Post by **jsc** » Tue Aug 28, 2012 9:11 am

David, someday, could you add the ability to find intersections between curves and reference lines? New points would be added to the real curve, not the reference line, naturally. Reference lines would only show up in one side of the selection boxes, ie,

"Find intersection of this curve:" (only real curves - and these are the curves where the points are added?)

"with this curve [or reference line]:"

Sorry if I have this the wrong way around, but I think the intent is clear.

I just want to be lazy and not have to lay in a "real" curve with which to calculate the intersections!

Thanks in advance.

Post by **DPlotAdmin** » Tue Aug 28, 2012 10:31 am

Shouldn't be a problem.

jsc · Post by **jsc** » Tue Aug 28, 2012 1:59 pm

Thanks, as always!

jsc · Post by **jsc** » Thu May 21, 2015 2:44 pm

Still would like this capability if at all possible! (ie, intersection of a real curve with a reference line, with any added points being added to the real curve.)

Thanks.
Jon