Page 1 of 1
command line bug in v2.1.6.1 ?
Posted: Thu Mar 13, 2008 1:34 pm
by oneto
Hello,
I use the following options on command line (from inside Textpad)
Code: Select all
dplot /x3y10,11,12,15,16 $File /m ClkSts
(where $file stands for the currently open file and ClkSts is a macro) and this seems broken since I upgraded to last version. I don't remember which version I had before. Now it seems to ignore the switches and oepn the dialog to select columns...
Any clue ?
Thanks a lot in advance !
Jean-Louis
Posted: Thu Mar 13, 2008 1:49 pm
by DPlotAdmin
Jean-Louis,
That's most likely a side effect of a change in version 2.1.6 that I didn't think enough about. The "Pick columns to plot" setting is now remembered from one session to the next. I should be ignoring that setting when the columns are specified on the command line, but... I'm apparently not. But you can fix this by unchecking that box, then closing DPlot.
command line in v2.1.6.1
Posted: Thu Mar 13, 2008 1:49 pm
by oneto
Hello again,
In fact it seems that only the /x and y switches are ignored: if I select manually the columns, the macro execute automatically after that.
Hope that helps,
Jean-Louis
Posted: Thu Mar 13, 2008 1:53 pm
by oneto
David,
Thanks a lot, your suggestion worked great !
Have a nice day,
Jean-Louis